Stenocereus Hystrix – RARE!! Similar to Peruvian Torch & Peyote
you can see in the table, Phalaris Tuberosa does not have
particularly high DMT levels, but it does have quite a bit of
5*Me-DMT. It appears that the alkaloid content of Phalaris
Tuberosa is such that one dose of DMT also includes a dose of 5-
Me-DMT. So Phalaris Tuberosa is actually just as strong as the
other plants containing minimal 5-Me-DMT. The DMT in Phalaris
Tuberosa should contribute visual hallucinations to the trip.
The bad news for Phalaris Tuberosa is that it contains
bufotenine. But even a large dose of Phalaris Tuberosa (100g
containing 100mg DMT and 22mg 5-Me-DMT, a full dose of each)
contains 5g of 5-OH-DMT, one half the dose given in the study
cited in Ott. Most phalaris users report that they ingest or
smoke the product. Such an administration route is less sudden
and "shocking" than injection. Perhaps this will temper the
effects of 5-OH-DMT. Caution should still be used with Phalaris
Tuberosa. Phalaris arundinacae and desmanthus illinoesis,
containing no 5-OH-DMT, appear to be safer, but lacking in 5-
The phalaris plants are tall grasses. They grow well in
Australia, around the Mediterranean sea, and all over America.
They grow in clumps up to 7 feet tall. Desmanthus Illinoisis is
also called "Illinois Bundlweed." It's a bush that grows,
obviously, in the Illinois area. Psychotria species are the yopo
used in South American ayahuasca potions.
ALKALOIDS REPORTED AS mg PER 100g RAW DRIED PLANT,
AND AS PERCENT OF TOTAL PLANT SOURCE WEIGHT.
DMT 100 mg .100%
5-Me-DMT 22 mg .022%
5-OH-DMT 5 mg .005%
file:///C|/Documents%20and%20Settings/All%20Users/...0Culture/Ayahuasca%20and%20DMT/DMT%20FAQ%202.0.txt (7 of 13)4/14/2004 9:11:34 PM
P. Tuberosa ('net gossip)
DMT 170 mg .170%
5-Me-DMT 60 mg .060%
P. Arundinacea ('net gossip)
DMT 60 mg .060%
Desmanthus Illinoisis (root, from Ott)
DMT 200 mg .200%
Desmanthus Illinoisis (root bark only, from Ott)
DMT 340 mg .340%
Psychotria species (averaged, from Ott)
DMT 200 mg .200%
Unfortunately, sheep herders in Australian desired strains
of low alkaloid phalaris plants. So now most commercially
available phalaris are probably weak. Phalaris can be obtained
through mail order herb companies, some of who advertise high
alkaloid plants. Because I do not wish to associate these fine
suppliers names' with an article on how to prepare a drug, I will
not provide names or addresses. Just ask around on the net.
XXXXXXXXXX SHEEP DEATH XXXXXXXXXXX
I put this as a separate section to highlight it's
significance. Remember, if you try these drugs, you are using
something that kills sheep. The toxic syndrome is called
"phalaris staggers." It is manifested by apparent dizziness,
AYAHUASCA VINE About Forum
android-app://com.google.android.googlequicksearchbox/ (Some websites, no joke, charge you extra for the funnel
4-aco-dmt vendor About Forum
Caupuri Caapi Vine (Banisteriopsis Caapi)
e mental discipline. People who cannot endure the
bitterness of peyote often go to various extremes to get it into the system without
having to taste it. One fairly effective method is to drink unsweetened grapefruit
juice while chewing it. The acids in the juice somewhat neutralize some of the
bitter bases. Another method is to grind the dried buttons in a pepper grinder and
pack the pulverised material into OOO capsules which are washed down with
warm water. This is an effective method but it can take 20 capsules or more to
get a 350mg dose of mescaline. Often people will boil the buttons in water for
several hours to make a concentrated tea. A cup of this decoction can be
swallowed in a few hasty gulps. Another preparation that is occasionally used is
a jello-type dessert made with the fresh or dried plant. If spoonfulls are
swallowed whole the gelatine serves as a sort of shield protecting the tastebuds
from contact with the bitter material. It also slows down the the absorption of the
drug in the digestive tract. This can be of value. It is generally recommended that
anyone consuming peyote or mescaline ingest it gradually during a period of an
hour or take two half doses 45 minutes apart. This is done to reduce the shock of
the alkaloid to the system. Nausea or queasiness is sometimes experienced half
an hour or so after taking peyote or mescaline. This usually passes in less than
an hour. A sip of grapefruit juice will sometimes dispel the sick feeling. During the
peyote ceremony Indians encourage vomiting rather than restraint if the urge
presents itself. Throwing up, they believe, is apurging of both physical and
spiritual ills. Most tribes fast for at least a day before taking peyote. This can also
help to minimize gastric distress. One should not have eaten for at least 6 hours
before taking either mescaline or peyote.
A method which avoids both the bitterness and the nausea is the rectal infusion.
8-16 grams of dried peyote is ground into a fine powder and boiled in a pint of
water for 30 minutes. It is then strained and further boiled to reduce it's volume to
one half pint. After cooling, this is taken as an enema using a small bulb syringe
and retained for at least two hours. If there is any fecal matter in the lower bowel,
a small cleansing enema should be taken and thoroughly expelled before having
the peyote infusion. Otherwise much of the drug will be taken up by the feces
and later voided.
FINDING AND PICKING PEYOTE
The peyote cactus may be found in many areas throughout the Chihuahuan
Desert from central Mexico to southern Texas. When a site is found where
peyote grows it usually does so in abundance. Sometimes it grows in open sunlit
places, but more often it is found in clusters under fairly large shrubs, among
mesquite or creosote bushes or in the shade of large succulents.
The best time to harvest any cactus is after a long dry spell. The worst time is
during or after a rainy period.
Caupuri Caapi Vine (Banisteriopsis Caapi) About Forum Mckenna Terence Mckenna
put into a 500 ml flask along with a solution made up of 150 ml ethyl
alcohol, 150 ml water, and 100 grams KOH. Next, 15 ml of hydrazine
hydrate is added. This hydrazine should be the monohydrate, which is
64% hydrazine. If a weaker variety has been scrounged up, this can be
made to work by adding more, and using less water.
Now the flask should be fitted with a condenser, and flushed with
nitrogen. Then heat the flask in an oil bath to gentle boiling for 4
hours. A slow stream of nitrogen to the flask during the reflux averts
the danger from hydrazine.
The flask is next cooled, and the contents poured into a sep funnel of
at least 1000 ml capacity. The batch is then extracted with 600 ml
ether, followed by 600 ml of an 85-15% mix of ether and alcohol.
Finally, one more extraction with 600 ml of 85-15% ether-alcohol is
All of the desired product should now be extracted into the
solvent, and out of the water. This fact should be checked using a
black light to look for the characteristic blue fluorescence.
The combined solvent extracts should now be lowered to a pH of
about 2 using HC1. At this point, a precipitate should form, and it
should be filtered out. The precipitate should be washed free of
entrained product with 4-1 ether-alcohol, and the washing added to
the rest of the filtered solvent.
Now 2750 ml of water should be added to the solvent, and the
mixture placed in a gallon and a half glass jug or 5000 ml beaker. To
this should be added 3 portions of cation exchange resin in H* cycle.
Cation exchange resin is a common item of commerce used in
deionized water systems. Check the yellow pages under "water" and
see which of the local Hive Ephedra Culligan men offer deionized water systems.
The deionizers come in two-tank systems with one tank packed with
cation exchange resin to remove calcium, magnesium and sodium
from the water.
The other tank has an anion exchange resin to remove
chlorides, sulfates, and so on. It is no great task to buy cation
exchange resin from these outlets. The resin consists of tiny plastic
beads coated with the exchanger. In the case of the cation exchangers,
Practical LSD Manufacture
this is generally a sulfonate. "In H* cycle" means that the resin is
charged up and ready to go. This is generally done by soaking the
resin in 20% sulfuric acid in water for a while, then rinsing with
Check the directions on the container of resin. Steer
clear of mixed resins that contain both anion and cation exchangers. If
the Culligan man is too stupid to know the difference, or doesn't
know what he has, keep looking until you find one who knows his
The treatment with three portions of cation exchange resin in H*
cycle should be done as follows: Each portion of resin should weigh
about 15 grams. The first portion is added, and then the mixture
should be stirred strongly or shaken for about 10 minutes. The product
will come out of the liquid, and stick
ayahuasca About Forum
@Tuesday, September 25, 2018 4:34:11 PM